FAQ
Hardscaping in North Hollywood, answered
The questions we hear most from North Hollywood homeowners.
Hardscaping is the built, unplanted part of a yard, and specifically the dry laid part. That covers paver patios, walkways and driveways set on aggregate, natural stone laid on a base, gravel and decomposed granite surfaces, steps, low seat walls, borders and edging, plus the drainage running beneath any of it. What separates it from concrete and block work is method, since nothing is poured and nothing is mortared. The strength comes from a properly compacted base, tight joints and a restrained edge. Built correctly, a dry laid surface flexes slightly with the ground instead of cracking across it.
The two look similar when finished and behave nothing alike. A poured slab is one rigid piece, so ground movement shows up as a crack somewhere you did not choose. A paver field is hundreds of individual units over compacted rock and bedding sand, so small movement spreads across many joints instead of splitting one surface. Pavers can also be lifted and put back, which matters when a pipe, a sleeve or a settled corner needs attention. Concrete usually costs less per square foot up front. Pavers cost more and are far easier to live with over time.
Access is the first thing we measure on a job like this, because base rock and pavers are heavy and there is usually one narrow path to the back. We check gate width, the pinch between the house and the fence, and whether the ground along that route can carry a machine. Where a compact loader fits, it does the hauling. Where it does not, material moves by barrow in small loads and we lay plywood or plates so the walkway and the lawn survive. Spoil from the excavation comes out along the same route to a truck at the curb.
Under a finished paver surface sit three layers, and the job is only as good as they are. First the subgrade gets excavated to depth and compacted. Then crushed aggregate goes in and gets compacted in lifts rather than all at once, because a thick single layer never densifies properly. Then a thin screeded bedding layer receives the pavers. Depth depends on use, so a patio needs less than a driveway carrying vehicles. Compaction is the part nobody ever sees and the part that decides whether the surface still reads flat five years from now.
A level lot has no natural fall, so drainage gets built in deliberately. We pitch the finished surface slightly away from the house, enough to move water without being noticeable underfoot, and we pitch the compacted base the same direction so nothing collects beneath the pavers. Where the yard cannot shed water at its edge, a channel drain along the patio or an area drain at the low point picks it up and a solid line carries it away. With the neighboring building close, that line has to run somewhere legitimate rather than over a property line.
Bigger is not automatically better on a lot this size. A dining table with the chairs pulled out needs more room than most people estimate, and a lounge grouping needs more still, so we lay the real furniture footprint on the ground before agreeing on dimensions. Past that point, extra paving mostly steals space from planting, which is what makes a small yard feel like a garden rather than a slab. In tight yards the stronger move is usually a right sized patio with generous planted edges and screening along the fence, not paving to the property line.
Movement in a dry laid surface almost always traces to one of three failures: base rock that was never compacted in proper lifts, no edge restraint holding the outside course, or water washing under the base because drainage was ignored. Get those right and a paver field stays flat under normal use for a very long time. We compact to spec, install restraint on every open edge, and build the base to shed water rather than hold it. If a section ever does settle, the repair is straightforward, since the pavers lift out and go back.
Sun exposure matters more here than most people expect, since these yards take direct light and long hot afternoons. Very dark pavers and dark stone absorb heat and become genuinely uncomfortable barefoot, which is worth knowing before choosing a color off a small sample. Lighter and mid tone units stay usable in summer. Dense concrete pavers and hard natural stone both handle heat and ultraviolet exposure well, while softer stone can flake and some sealers yellow in strong light. We look at samples outdoors in daylight rather than under showroom lighting.
Decomposed granite is an affordable, honest surface for paths, side yards, seating nooks and areas under trees, and it drains freely, which suits level ground. It does need a compacted base, a firm edge to hold it, and stabilizer if you want it to resist tracking and washing. Loose gravel is cheaper still and works well as a mulch or a utility surface, though chairs do not sit well on it. Both track indoors when there is no transition at the door, so we usually pair them with a paved landing.
Yes, and hardscape stages better than most work provided the base decisions get made early. The order to protect is grade, drainage and anything that has to run beneath a surface, such as an irrigation sleeve or a conduit. Once those are in, the patio can be built now while the walkway, the seat wall or the front path follows later without disturbing what is finished. We draw the full layout even for a partial build so the second stage lines up with the first. Each stage is scoped and priced separately in writing.
For a rental or a shared courtyard, durability and simple upkeep beat anything decorative. Concrete pavers over a properly compacted base take heavy foot traffic, dragged furniture and occasional neglect without complaint, and a damaged unit can be swapped out rather than patched. Wider, well restrained walkways stop tenants cutting corners across planting beds. We keep joint patterns simple, avoid fragile stone and intricate layouts that are expensive to repair, and use hard edging so gravel and mulch stay where they belong. The aim is a surface that still reads well with no attention at all.
A low seat wall does two jobs in a compact yard, holding a grade change or a planting bed while giving seating without furniture taking up floor. That is a real advantage where every foot counts. Borders and edging do something less visible but just as important, since they restrain the outer course of paving and keep gravel, mulch and decomposed granite from migrating into the lawn. Whether a wall belongs in your plan depends entirely on how the space gets used. We would rather leave it out than pack a small yard with masonry.
Even on level ground there are usually a few inches to resolve between a door threshold, a patio and the yard, and steps are how that gets handled cleanly. A dry laid step needs a compacted base underneath and a consistent riser height, because inconsistent risers are the most common cause of a trip. Where a step runs more than a single course, we build it so the units cannot creep forward under load. On a small terrace, one broad step often reads better than two narrow ones and doubles as extra seating.
We sweep sand into the joints and compact it in, then top it off, because the sand locks the units against one another and turns a field of separate pieces into one working surface. Polymeric sand hardens after wetting and resists washout and casual weed growth better than plain sand does. Nothing stops a seed landing on top of a patio, so an occasional weed appearing in a joint is normal rather than a defect. Blowing debris off and topping up joint sand every few years is most of the upkeep a paver surface ever asks for.
Straight paving at grade, walkways, patios and gravel surfaces generally do not require review. What does come up is a wall over a certain height, work that changes how stormwater leaves the property, and anything touching the public right of way at the front of the lot. On tight lots with buildings close on both sides, drainage is the question that surfaces most often. We check what applies to your particular scope before starting, and we would rather tell you a permit is needed than build something that has to come back out.
Working on a dense block means the neighbors feel the job nearly as much as you do, so we plan around it. Cutting happens with water or dust collection rather than dry sawing in the open, the work area gets contained, and the compactor runs during reasonable hours instead of early morning. Material stays stacked tidily rather than spread across the sidewalk, and the site gets swept at the end of every day. Fences and shared walls are protected before demolition begins. None of that is complicated, but it separates a smooth job from a complaint.
One licensed contractor builds it, start to finish. The same company excavates, compacts the base, screeds the bedding layer, sets the pavers, cuts the edges and installs the restraint and joint sand. Daniels Landscaping stays accountable for the work. Base preparation is where hardscape succeeds or fails, and it is completely invisible once the surface is down, so we are not willing to have somebody else do it and simply hope. One team, one standard, one company answering for the result if anything ever needs attention.
Pricing starts with a walk of the property, because square footage on its own tells us very little. Access, excavation depth, how much spoil has to leave, drainage, cuts and the material you choose all move the number. Call (818) 443-9300 and we will come out, measure, talk through layout, and give you a free written estimate spelling out base depth, materials and scope rather than one lump figure. Daniels Landscaping is licensed in California under number 1138709. The estimate costs nothing, and it is written so you can compare it honestly against another bid.